We must not only learn to use the machine, but also learn to avoid some misunderstandings. This will not have a certain impact on our use and in all aspects. The same is true of the automatic assembly machine. What about some misunderstandings? Let ’s talk about it for the editors of automatic assembly machine manufacturers.

 

   1. In the design of automatic assembly equipment mechanism: In many companies, a project, regardless of size, is based on a single engineer. The design is messy and there is no supervision. Except for himself, others cannot modify it. It is more difficult to improve the follow-up.

 

   2. Some counterparts' designs are like building blocks. The machines made are like small trees, and their hands are shaking. The machine hasn't been used for long. Like the classic bicycle, the screws are often loose and cannot even be adjusted again. It is impossible to get rid of the tall thinking of using imported standard manipulators, just one hand, the efficiency may not be high.

 

   3. The design of various theoretical parameters is based on the feeling: never calculated, there is no standard calculation parameters, regardless of mechanics, structural accuracy, product tolerance caused by positioning drift, actual use clearance, rigidity, "ideal design of wear". Once the actual machine was made, it could not run normally, there was no room for modification, and a basket of tires was defective. In the end, disputes occurred, which cost time and money.

 

   4. The mechanical designer has no experience in processing parts, only knows the standard tolerances, and does not know whether it is reasonable or not. Because of the delivery cycle, there is no time to change the design and redo. Basically, things are installed, and eventually failures occur frequently.

   5. In terms of electrical wiring and software: Many companies do not outsource everything, but use a single electrical engineer as a unit, with cluttered wiring, different thinking, and messy procedures. Other than this engineer, others cannot modify it. If you want to improve or maintain it later, it will be more difficult and impossible.

 

   6. The non-standard automation equipment industry is an industry with a wide range of knowledge. Many units have insufficient knowledge and experience reserves, poor early design, and inadequate supervision. The initial management is not good, the design is not good, although the delivery is fast, but the customer cannot use normally, and the after-sales service is also empty words.

 

   7. Analysis of automatic assembly machine equipment manufacturers. Many companies have only design and assembly capabilities, no parts processing capabilities, and even no auxiliary equipment for repair. There is no standard parts library. There is almost nothing. The delivery time does not wait for people to arrive. In the end, everything worked out, and it was obvious that the grinder was needed to grind. Finally, the angle-oriented grinding wheel was selected for manual grinding.